3.3 If the end of a fillet weld is located on the closure edge of a section, a length of approximately 200 mm should be left unwelded at that section for the time being; this section should be welded only upon closure, as shown in Figure 4(c). b) After tack welding the longitudinal girders, web plates and inner bottom plate flat assemblies

3.3 If the end of a fillet weld is located on the closure edge of a section, a length of approximately 200 mm should be left unwelded at that section for the time being; this section should be welded only upon closure, as shown in Figure 4(c). b) After tack welding the longitudinal girders, web plates and inner bottom plate flat assemblies

3.3 If the end of a fillet weld is located on the closure edge of a section, a length of approximately 200 mm should be left unwelded at that section for the time being; this section should be welded only upon closure, as shown in Figure 4(c). b) After tack welding the longitudinal girders, web plates and inner bottom plate flat assemblies

General Principles of Welding 1. The welding terminology used in this document is as set out in GB/T 3375-1994. 2. Hull structural components or sections shall be kept to the correct dimensions and with uniform assembly gaps during assembly. Components or sections that do not comply with the drawings, standards and process requirements